Underlayment
The deck is covered in underlayment made for metal with an ice barrier at the eaves and valleys.
Metal Roofing
Metal Roof Installation Flanders, NJ
A roofer in Flanders can install a new metal roof in standing seam, exposed fastener panels, metal shingles or stone coated steel, with fasteners, flashing and trim detailed for thermal movement. Dial (862) 453-8002 to talk with a local roofer about a metal roof.
The first choice in any metal roof installation is the panel system. Exposed fastener panels, such as corrugated and ribbed panels, are screwed through the face and go on quickly, but every screw has a washer that will need attention someday. With standing seam, hidden clips hold the panels and let them move, which is why it is the premium residential choice.
Next comes the metal itself and the paint on it. Most residential panels are coated steel, with aluminum preferred near the coast and copper or zinc used for accents and high-end work. A fluoropolymer (PVDF) paint finish holds color longer than a silicone modified polyester finish, and 24 or 26 gauge steel is typical for homes.
What goes under the metal is easy to overlook and important to get right. Panels normally go over solid sheathing and a heat-rated underlayment, with an ice barrier in the eaves and valleys. Open purlin framing works on outbuildings, while homes are better served by a full deck.
If the problem goes deeper than it first looked, a Flanders roofer may also recommend standing seam metal roof or metal roof replacement.
Looking for Flanders metal roof installation? Call (862) 453-8002 to reach a nearby roofing contractor.
Call nowThe process
The steps of a metal roof installation
Here is the usual order for a new metal roof.
Pick the panel
Panel profile, gauge, paint system and color are settled, and the roof is measured so panels can be cut to length. Many panels are made to the exact length of each slope.
Get the base ready
The old roof is torn off or, where code allows, the metal goes over one layer of shingles with battens or underlayment between. Flat decking also helps prevent oil canning.
Lay the underlayment
A heat-rated underlayment goes down over the whole roof, plus an ice barrier in leak-prone areas. This layer is the backup if water ever gets past the metal.
Set the trim
Edge trim at the eaves and valley metal are installed before the panels. Rake trim and ridge cap come later and overlap the panels.
Run the panels
Each panel is aligned, lapped and fastened so the roof stays straight from end to end. Cut edges are kept clean of metal shavings that rust.
Ridge closures
The ridge, walls, chimneys and pipes are flashed, and closures seal the gaps under the trim. On roofs that hold snow, snow guards keep it from sliding off in a sheet.
What is included
Parts of a metal roof system
System choice
A panel system matched to the roof pitch with a finish chosen for long color life.
Matched trim
Eave, rake, ridge, valley and wall trim in the same finish for a clean, finished look.
Ridge ventilation
Closures fill the gaps under the trim while keeping out rain and pests.
Penetration boots
Pipe boots made for metal and snow guards over entries finish the job to protect people and gutters below.
Related service
Metal Roofing Contractor Flanders, NJ
Choosing a metal roofing contractor means finding someone who installs metal regularly, not occasionally. It is fair to ask about the panels they prefer, the gauge they recommend and how they flash chimneys and walls.
A metal roofing contractor in Flanders should talk you through panel, gauge, finish and snow guards without pushing one answer. Driving past a couple of their finished metal roofs tells you a lot about their detail work.
Related service
Stone Coated Steel Roof Flanders, NJ
A stone coated steel roof uses steel panels coated with stone granules set in an acrylic base, shaped to look like shake, tile or shingles. It handles hail and wind well, weighs a fraction of tile and has a quieter surface than bare metal.
Most stone coated steel goes on a batten system that adds ventilation beneath the panels. On a Flanders house that wants the look of tile or shake, stone coated steel avoids the extra structural load.
Related service
Metal Shingle Roof Flanders, NJ
A metal shingle roof uses smaller interlocking pieces stamped to look like shingles, slate or shake. Hidden fasteners and small units make them a good fit for roofs with dormers and valleys.
A metal shingle roof gives a Flanders home the look of shingles or slate with the lifespan of metal. Installation details like starter, valleys and ridge are specific to each product line.
Local help
Metal Roof Installation Near Me
Around Flanders, metal roofing shows up on new homes, reroofs of older houses, garages and farm buildings. From Flanders out to neighboring towns such as Budd Lake, Succasunna, Ledgewood and Chester, shingle roofs are being replaced with standing seam on many houses, and ribbed panels remain common on outbuildings, and a roofer who installs metal regularly will know which system fits each kind of building.
Need metal roof installation around Flanders? Call (862) 453-8002 for a Flanders roofer who serves the towns around it too.
How the weather here affects roofs around Flanders
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Flanders is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Roofers who know Flanders
Local roofers see the same roofs and storm damage across Flanders and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Metal Roof Installation FAQ
What is the difference between exposed fastener and standing seam?
The difference is in how the panels are held down. Exposed fastener panels are screwed through the face, which is simpler and quicker but leaves washers that will need replacing, while standing seam uses hidden clips that let the panels move. Standing seam is the usual pick for homes, exposed fastener for outbuildings.
What is the lifespan of a metal roof?
Lifespan depends on the metal, the finish and the installation. Concealed fastener systems usually outlast exposed fastener roofs, which need periodic screw replacement. Salt air, scratches and poor installation shorten that life.
Does metal roof thickness matter?
Gauge describes thickness, and a lower number means thicker metal. Thicker metal resists dents and oil canning better. Ask the roofer which gauge suits your roof and local weather.
Is a metal roof more likely to be struck by lightning?
Metal roofs do not attract lightning. Strikes depend on height, terrain and nearby objects, and a metal roof is no more likely to be hit than any other roof. Metal is also noncombustible, which helps if a strike does occur.
Is a metal roof louder in the rain?
On a house with decking and attic insulation, a metal roof is usually only slightly louder than shingles. Panels fastened to purlins with nothing under them make the most noise. Granule-coated metal is quieter yet.
More questions? Call (862) 453-8002
Related services
Standing Seam Metal Roof
Long-lasting standing seam roofs, from snap-lock to mechanically seamed panels, with matching trim, closures and snow guards.
Learn moreMetal Roof Replacement
Full metal roof replacement, panel replacement and metal re-covers over existing roofs, with purlins and decking checked before new panels go on.
Learn moreRoof Installation
Putting on a new roof the way the material maker intends, whether it is asphalt shingles, metal or another material.
Learn moreCommercial Metal Roofing
Metal roof systems for commercial buildings, including new installs, replacements and leak repairs, planned around the building and its operations.
Learn more
Looking for something else?
See all roofing servicesNeed metal roof installation in Flanders, NJ?
Call (862) 453-8002 to talk to a roofer serving Flanders, NJ.